How to Use Vibe Tap

Follow these steps to set up and use Vibe Tap to wirelessly cast your computer screen to Vibe board without needing a network connection.

Updated over a week ago

This article applies to the Vibe Board S1 55"/S1 75".

If you are using the Vibe Board Pro 75", please check this article.

💡 Vibe Tap's functions and limitations

  • Vibe Tap can only cast to Vibe Boards, not other devices.

  • The Tap's USB-C port requires a device with a USB-C port that supports DisplayPort (DP) protocol. If your device only has an HDMI port, you will need an HDMI to USB-C Adapter. Here is the recommended device

Instructions to Pair Vibe Tap to your Vibe Board

  1. Plug the Vibe Tap into port "1.USB-C" or "2.USB-C" on your Vibe board. Your board will detect Vibe Tap and complete pairing.

    1. If pairing fails, try re-plugging Vibe Tap.

  2. After Vibe Tap completes pairing with your board, unplug it from your board and plug it into the USB-C port of your PC, which supports the DisplayPort protocol.

  3. Vibe Tap will automatically match the last paired board. The light will blink white during pairing.

  4. Wait for your board to confirm successful pairing. The Vibe Tap light will be solid white when connected.

  5. Press the Vibe Tap button to start casting your PC screen to the board. The light will turn green when casting is successful.

    • You can switch between "Mirror" and "Extend" display modes from your PC.

    • Window PC: Press Windows logo key + P. More details.

    • MacBook: Please follow this article.

💡 Note:

  • If you want to cast to the last paired board again, just plug Vibe Tap directly into your PC without re-pairing.

  • To pair a new board, long press the Tap button for 3 seconds to forget, then follow pairing steps again.


💡 Tip

Need more help?


Did this answer your question?