Skip to main content
How to use Vibe Tap on the Vibe Pro 75"

Follow these steps to set up and use Vibe Tap to wirelessly cast your computer screen to Vibe board Pro 75".

Updated over a week ago

This article applies to the Vibe Board Pro 75".

πŸ’‘ Vibe Tap's functions and limitations:

  • Vibe Tap can only be cast to Vibe Boards, not other devices.

  • The Tap's USB-C port requires a device with a USB-C port that supports DisplayPort (DP) protocol. If your device only has an HDMI port, you will need an HDMI to USB-C Adapter. Here is the recommended device


Instructions to Pair Vibe Tap to your Vibe Board Pro 75"

  1. Make sure Bluetooth is enabled on your Vibe Board Pro 75". Plug the Vibe Tap into the USB-A port of your Vibe Board Pro 75". You will see a pairing notification on the Vibe Board.

  2. On the Vibe Board Pro 75", select "Pair" and wait for successful pairing. You will see a confirmation screen when paired.

    1. If pairing fails, try re-plugging Vibe Tap.

  3. Vibe Tap will automatically match the last paired board. The light will blink white during pairing.

  4. Wait for your board to confirm successful pairing. The Vibe Tap light will be solid white when connected.

  5. Press the Vibe Tap button to start casting your PC screen to the board. The light will turn green when casting is successful.

    • You can switch between "Mirror" and "Extend" display modes from your PC.

    • Window PC: Press Windows logo key + P. More details.

    • MacBook: Please follow this article.

πŸ’‘ Note:

  • If you want to cast to the last paired board again, just plug Vibe Tap directly into your PC without re-pairing.

  • To pair a new board, long press the Tap button for 3 seconds to forget, then follow pairing steps again.


πŸ’‘ Tip

Need more help?


Did this answer your question?