This article applies to the Vibe Board S1 55"/Vibe Board S1 75" new smart stylus.
If you are using the Vibe Board S1 55" (Intel i5) old smart stylus, please check this article.
If you are using the Original Vibe Board 55", please check this article.
Function instructions
Status Indicator Light
Page Up Button:
Press this button to go back to the previous page in the Canvas app or to scroll up any webpage while browsing.
Page Down Button:
Press this button to proceed to the next page in the Canvas app or to scroll down any webpage while browsing.
Eraser Switch Button:
Single click
Switch between the Pen and Eraser
in the Canvas app and Annotation mode.
Single click
Start annotation on any app.
How to Pair the Stylus
Make sure the Bluetooth on your Vibe Board is turned on.
Click on any button on the stylus to initiate pairing.
Click "Pair" on the notification to complete.
How to Charge the Stylus
Low battery
When the battery is low, the pen will flash red light when any key is pressed.
USB-C charging port
The USB-C charging port is at the top of the stylus.
Charging
Use a USB-C cable to charge the stylus.
If you want to connect the board to charge the stylus, it is recommended to use Port 1 USB-C.
When charging, the red light stays on.
When fully charged, the red light will turn into a green light.
When the charging process is disconnected, the indicator light turns off.
Magnetic Stylus
The stylus is magnetic, it will stick to any edge of the Vibe board but the best position is shown in this image.
๐ก Tip
Need more help?
Send an email to our Support Team or Submit a Support Ticket.