This article applies to the Vibe Board S1 55″ and the Vibe Board S1 75".
If you are using the Vibe Board Pro 75″, please check this article.
If you are using the Original Vibe Board 55″, please check this article.
Preparation:
Determine the type of USB port you have on your computer to see which specific cables are required.
We recommend using cables that are shorter than 15ft to prevent connection failures caused by insufficient signal strength.
Scenario 1:
If your laptop has a USB-C Display port as shown on the image below, you will require a USB-C Video Monitor Cable.
💡 Note: This is our most recommended connection type.
Connection flow:
Instructions:
Connect the USB-C Video Monitor Cable from your computer USB-C Display port to the "Touch" USB-C port on Vibe Board.
Touch the HDMI icon on the launch bar to open the Input Sources menu.
Press the "TOUCH" Switch button
Then you will have screen-casting/annotation/touchback.
💡 Note: you need to go into "Full-Screen Mode" for "touchback" to work.After the screen-casting has been connected, if you split the screen, touch the Vibe screen and you will see a button in the right corner to put the screen back into full-screen mode.
Scenario 2:
If your laptop does not have a USB-C port, but only has a USB-A port, as shown in this PC, you will require an HDMI cable and a USB-A/USB-C cable to achieve both screen-casting/touchback. Annotation is not available for this connection type.
Connection flow:
Instructions:
Connect the HDMI from your computer to the HDMI-IN port on the Vibe Board and plug the USB-A/USB-C cable from the USB-A port of your computer to the "Touch" USB-C port on Vibe Board.
Touch the HDMI icon on the launch bar to open the Input Sources menu.
Press the "HDMI IN" Switch button
You will have both screen-casting/touchback. Annotation is not available for this connection type.
💡NOTE: If the Touch functionality is not working, then try a different USB-A to USB-C cable, as some charging cables may not work with this configuration. Please try another cable or use the one we have tested here:
USB - A/C to USB-C Video Cable
Scenario 3:
If you only want to have a standard HDMI connection with screen-casting, you will only require an HDMI cable.
Connection flow:
Instructions:
Connect the HDMI from your computer to the "HDMI-IN" port on the Vibe Board.
Touch the "HDMI" icon on the launch bar to open the Input Sources menu.
Press the "HDMI IN" Switch button
You will have standard screen-casting. Touchback and annotation will not be available for this connection type.
💡 Tip
Need more help?
Send an email to our Support Team or Submit a Support Ticket.